Wheel sensor problem. Need HELP
Thiis post is NOT the typical trifecta lights problem. I have eliminated everything but the MALE right rear speed sensor conection. After replacing the sensor, I still had the lights. I did notice that there was very little length when I went into the box and pulled the connector out. I didn't think much of it until the sensor did not solve my problem. I then jacked the rear up as high as my jack stands would allow in order to get a better look. The male end of the connector was just two wires wrapped in electrical tape until one inch from the frame rail, where the insulation had been stripped back and spliced.
Does anyone know where I can get a new male connector? I have already removed the plastic runner to expose the wiring harness at the rear door, and marked off the two wires. I think I should replace the male clip and wires back to this part of the harness, but don't even know how to describe the part to a junk yard/recycler. There are no u pull it yards with a 2001-2005 330 or325xi within 50 miles of Norristown/Trooper wehre Ilive.
By any possible shot in the dark does anyone have a parts car, or know of somewhere I can get this section of wiring? Any help is really, REALLY appreciated.
Read responses in bimmerfest.com