Volvo Engine Mount Question
I bought my Volvo mounts (thanks Roger) and although there is no locating rectangular thing like the original mounts, it allows the engine mount bolt to move in the bracket. Should these be placed dead smack in the middle or leave the nut loose until the cross member is back in place then tighten...
LS3 in 82 Volvo 242
I've had the car for about 16 years -- it's been 5.0L Ford powered since 1996. Car has 220k miles on it - about 120k on the 5.0L. I'd mildly modded it over time (H/C/I/Exh) and it worked well. But I'd always wanted a bit more power and refinement so decided on going with an LS3. Weighed/studi...
MM install with engine out.
Hi All, 87 S4 Auto Volvo mounts I think..I got them from Roger about 4 years ago. I have read a great deal of posts and looking for advice from those that have installed them both ways. What is the easier way? 1. Install to engine first before I drop it in or, 2. Install to c...
Trying to find the best SBC --> LS motor mount adapters for my Volvo
Hey y'all, Getting ready to put my 5.3 back together and get it into my car. I have a 700R4 as well as a 4L60E, and I'm leaning towards using the 4L60E. I would very much prefer to keep the driveshaft I already have and of course also would like the transmission to stay in the same position i...
Got Volvo oil cooler, now WTF?
OK, I was going to be nice to my 78 and cool off the oil with this fancy oil cooler and sandwich plate from a turbo Volvo. "Bolts Right Up".....not!The sandwich plate has two sides: a flat side that mates to the gasket on the top of the oil filter, and the other side which has a recess for an o-r...
Question: Volvo motor mount and engine install
I am installing the motor tomorrow. I have replaced the motor mounts with Volvo mounts and have them buttoned down to the subframe and made sure the hooks were attached to the lower metal piece below. My question are as follows: 1) what would be the best way to ensure I can attach th...
Volvo Motor Mount Safety Hooks
Mine are touching after install, I will try and pry them apart. My question is how close is too close? And is it safe to run without the hooks (if I were to remove the round bottom plate).