Forumsee logo
Forumsee » Cars » General » Read message
RSS: Subscribe to RSS

Recoding F36

BMW Coding and Programming - Bimmerfest - BMW Forums - www.bimmerfest.com
I need to completely recode my 2016 435xi GC as the dealer installed new software when I had a battery problem. New software was required for the check control messages stored and the battery had to be replaced as it wasn't holding a charge at an acceptable level. So, of course all my coding has been wiped clean. I am waiting for the E-sys Launcher Pro from TM.

Unwarranted wake ups were also detected by an unknown control unit?

The only hardware change I have made in the car was to install a light switch (18 months ago) with a rear fog light button and activate that feature with coding. Worked fine. However during service the master tech noted: "Fault code set for wrong light operating unit variant installed". The actual fault code was not noted. I assume that the different light switch variant was not responsible for the unwarranted wake ups?

I believe that I need to code a change to recognize the different light switch variant and subsequently wipe the fault code that has been set.

Advice on how to do this will be much appreciated.


Read responses in bimmerfest.com

Tags


Last videos:

Long Beach Gran Prix - 3 Part Vlog Series
Long Beach Gran Prix - 3 Part Vlog Series
Steering Joint upgrade
Steering Joint upgrade
Whores Round Here vs THE WORLD
Whores Round Here vs THE WORLD
Repainting Brake Calipers
Repainting Brake Calipers
What if u could turn 14 RPM
What if u could turn 14 RPM
CR-Z on YouTube
CR-Z on YouTube
Test Driving C3 Corvettes
Test Driving C3 Corvettes
Detroit Auto Show Preview
Detroit Auto Show Preview
Cars · 
Mobility · 
Hardware · 
Motorbikes · 
Travel · 
Boating · 
Aviation · 
production-frontend
About Forumsee · Contact · Privacy policy · Request content removal
We use cookies for navigation analysis and personalized advertisement. By using our site, you agree to our use of cookies.
Accept  ·  Learn more