Forumsee logo
Forumsee » Cars » Performance & tuning

Messages labeled as 'Lexus'

1 2 3 4 5 6 7 Next >>   25 50 75

Today

My current situation is that I have done as much research as I can with answers to my o2 sensor question and I feel like I have tried them but i am not getting anywhere with it....

Yesterday

Can someone please confirm whether the boomslang harness for the IS300 for AEM FIC or other piggybacks includes the splice of the B1S1 and B2S1 sensors to make the stock ECU hap...

2 days ago

Mainly made this to help others. Took this from my previous post on this site. 6/16/2017 Just wanted to share what info i've gathered along the way while doing my swap. My c...

3 days ago

As the title states... I have a 2001 Lexus Is300 that I have converted to a 2JZGTE VVTi (Aristo Swap) Little back ground on the car: Car was running a month ago ...

7 days ago

Hello, I will be installing a Zex wet nitrous kit tomorrow and need some insight. Since I have a greddy emanage ultimate with boomslang harness, how do I wire up the EMU to act ...

8 days ago

Full Aristo swap on an "01, ecu, tranny, single Turbonetics. When the throttle closes abruptly the AFR's go really rich and it acts like it wants to stall. I adjusted the TPS ...

10 days ago

I finally installed AEM ems v2 (30-6050) on 2002 is300. Upgraded from GEmu. Can someone help or send me base start up cal for 2jzge na-t. 550cc injc GM IAT AEM 5bar map ...
so i'm installing my supercharger buti cant get my 550cc r\c injector to sit tightly in there...i check all the o -rings and everything sits fine but nut snug feels like there i...

11 days ago

So I've got a 02 5 speed Is300, and my front fuel injector is leaking horribly!!! It is literally pouring out everywhere inside my engine bay, and I have been looking and can't ...

13 days ago

I'm looking for tip and advice on running a na high compression. I have already torn down the block and am cleaning the crusties off. So my questions are. 1. Can I use the orig...

16 days ago

So I am going away from the multi-plate clutches that everyone wants. I've had enough of them. I had a clutch custom built by a shop here local that will (as tested) hold 750f...

17 days ago

Just completed my swap, new seals all around, single Turbonetics, 10psi spring til I sort everything out. Problem is I have an oil leak coming somewhere from the rear of the bl...

20 days ago

Hey guys, a popular mod for NA-T sc300 guys was to convert to IS300 coils and run the JDM Gte ecu with a thicker headgasket to lower compression. I had the mod done on my sc300 ...
Full Aristo swap, eng/tran/ecu, and the AFR's go really rich when the throttle closes; almost to the point of stalling. I'll admit I'm venting to atmosphere with the BOV but I ...
Full Aristo swap (eng/tran/ecu) on a 2001 IS. Ambient (outside temp reading) is "E" and I cant get the a/c compressor to engage. I've done some searching and have come up empt...

23 days ago

I was talking with a local Lexus Tech today who has a boosted IS. He runs an Emanage. We were talking about tuning and computer learing and he mentioned that he had a very dif...
I have tried to search about this conversion, but gave up because the stuff I have found is a few years old and came up with a DEAD END conclusions. Some were not IS300 related,...

27 days ago

1st off what is the best piggy back stand alone for my first gen is 300 with a 2jz gte swap and a large turbo running over 500 whpI was told with that engine I can't run a full ...
I currently have a xs power intake manifold with the RMR 82.5mm throttle body, what kind of throttle cable should I get? I know some people said a Land Cruiser throttle cable w...

More than a month ago

So I recently swapped in a Jdm 2jzgte 6 speed into my 02 is300, wire harness was done by dr tweaks, who did a pretty good job, the only problem I've had with the wiring was the ...
I've been doing some reading and it seems that most folks going NA-T on low boost are using STI pink or blue injectors that are around 565 or 550cc. These are also denso style t...
So i recently picked up a w58 that came off of a 1987 supra and i tried to swap the tailhousing from my w55, that didnt work so i ended up putting the original w58 tail housing ...
Hey guys. I have a 2001 IS300 with an Aristo 2JZGTE Swap, with a tweak'd harness on the stock Aristo computer. I found a good offer on an AEM v1 that I can't pass up if it will ...
I'm new to the 2jzge I know it's not exactly the gte lower compression ratio (I think) couple other small things and obviously a turbo and the five speed. I have a 2002 is30...
Pictures are no longer visible due to the photobucket upgrade crap. Can anyone send me pictures of what wire has to be cut or connected to a 12v. For my fuel pump to be at c...
1 2 3 4 5 6 7 Next >>   25 50 75
 

Last videos:

Aristo Throttle Body
Aristo Throttle Body
Crystallized brightness
Crystallized brightness
Kufatec A5
Kufatec A5
Jericho 5 speed?
Jericho 5 speed?
Jericho 5 speed?
Jericho 5 speed?
great video for noobs who want to see how the whole enchilada is put together
great video for noobs who want to see how the whole enchilada is put together
Balance Shaft Elimination Questions
Balance Shaft Elimination Questions
Balance Shaft Elimination Questions
Balance Shaft Elimination Questions

Tags

Cars ·
Travel ·
Pets ·
production-frontend
We use cookies for navigation analysis and personalized advertisement. By using our site, you agree to our use of cookies. Learn more