Forumsee logo
Forumsee » Cars » Performance & tuning

Performance and tuning

1 2 3 4 5 6 7 Next >>   25 50 75

Today

Just finished up another 600WHP+ stock block. Just this month alone I've done about 7-8 stock block evo all over 550WHP+. This car lives at 850ft+ elevation, so power does...
Looking for some advice on how to approach my current exhaust problem. I am current running a K-tuned slip fit racing header (4-1 i believe) to a Invidia Q300 catback exhaust. T...
I looking at rebuilding my High mileage k20a2 in my Rsx soon. I would like to gain some NA performance during the build as well. I'm looking to spend about $2000-3000 dollars an...
Hi all, I am struggling to find a brush that will go between the tight gap of my Brembos and standard 17 inch alloys, any suggestions, other than moving the car Curre...
So I'm in the market for a new gun, and I want to hear everybody's opinion on what would work best for me. I already have the Titan Tools "Vaper" cheapos in both 1.4 and 1.8, an...
I have my k10 strung all over the shop, got the few larger dents fixed and getting ready to start putting epoxy on it. Would you go ahead and get the interior of the truck pa...
Any body got any pointers on blending the rockers and cab corners. I am pretty sure I have seen a how to somewhere but can't find it.
This may sound obvious to some of you, but it came as a hard-learned lesson for me. So I figured I'd share this story, if nothing else just to put additional knowledge on the s...
anyone remapped 2.7 tdi? planning to go stage 2 dpf off n egr bypass. whta gains would i get and recommendations?
Hey I noticed that some people have Black valve covers and I really like how they look compared to the grey one that I have. Do the older models come in black? Or did y'all pain...
I just spoke to a local tuning shop and I'm wanting to be able to run using e85. I am NA but all I need are fuel pump and injectors (unsure what size). Anyone able to lead me to...
Pros and Cons of Carburated LS Motors (photos) By Bryan Wood
Going to be doing that soon. I take it those kits use the existing body covers? I want to get the paint shot but I'm going to hold off if the kits replace those covers. Thanks!
I'm going to go with an NRG steering wheel. Wondering if anyone has used any of the cheap ebay hubs and/or quick releases with success. Rather not spend another $80+ on a h...
While at Miatapoolusa, I bought a Top Boot and it has some straps on it and i was wondering what they are for? If this is an OEM top boot or ? Any insight would be appreciated. ...
My Club has the factory Bilstiens which are fine for now (and under warranty), but will be swaped out in the future for a good set of coilovers. That said, I want to start wor...
I've got a 2012 mx5, HT, 6 speed man, etc.... I love my car but the power is a bit embarrassing to say the least. I'd love to know the most affordable way to get to 200hp. The r...
So I installed be steal braided power steering lines and my driver front o2 sensor now hit the fitting. I found they sell 90 degree fittings you screw in place of the o2,then ...
So the dealership has had my 05 GTO for 4 days now trying to relearn the new ecu and pair it to my car. They get clear to the end where it pairs the anti theft and they say mine...
Working with a turbo LS engine. (done several now with the MS3 now). I usually end up flat lining the IAT/MAT table because of this which causes some issues Id like to avoid. Ma...
Hi Guys, I read a lot about C6 Vettes in the past months and finally came to a point where i have to ask to you gentlemen for help. Had mine for just a few months and is ...
Took my 05 C6 to Scoggin Dicky dealer to have a tune up. Was quoted around $500 for tune and servicing fluids, general check up, plug wires if needed. Asked about replacing...
Seeing strange torque readings when car hooks hard, especially 1st and 2nd gear. Looked like torque management but disabled all of that. There should be a way to confirm clut...
so i have a evo 4 i was looking for a o2 dump pipe for it and came across one for a evo 7. with my understanding they all have the same turbo flange. so im thinking of ordering ...
Hi my evo9 appear to have whining noise in 4,5 gear the noise start at 2000rpm but went away after 3000rpm and it only whining when in gear. Car has done 100,000 KM's just chang...
1 2 3 4 5 6 7 Next >>   25 50 75
 

Last videos:

great video for noobs who want to see how the whole enchilada is put together
great video for noobs who want to see how the whole enchilada is put together
Balance Shaft Elimination Questions
Balance Shaft Elimination Questions
Balance Shaft Elimination Questions
Balance Shaft Elimination Questions
Unicorn RHD EVO IV
Unicorn RHD EVO IV
Centrifugal supercharger vs turbo, in Miata's
Centrifugal supercharger vs turbo, in Miata's
Centrifugal supercharger vs turbo, in Miata's
Centrifugal supercharger vs turbo, in Miata's
Centrifugal supercharger vs turbo, in Miata's
Centrifugal supercharger vs turbo, in Miata's
MAPerformance EVO X Cast Vband Turbo Kit
MAPerformance EVO X Cast Vband Turbo Kit

Tags

Cars ·
Travel ·
Pets ·
production-frontend
We use cookies for navigation analysis and personalized advertisement. By using our site, you agree to our use of cookies. Learn more